PROBLEM

POSSIBLE COUSE

REMEDY

The battery is not inserted corectly

Observe the position of the metal connectors.

1. The battery is too weak.
2. The automatic switching off function is activated.

1. Charge the battery.
2. Swtich the device on again.

1. The internal memory or card is full.
2. The shutter release button has not been pressed all the way down.

1. Delete photos, movies or mp3 from the memory.
2. Install a new card.
3. Press the shutter release button all the way down.

1. The flash is switched off.
2. The battery is too weak.
3. The series mode or movie mode is set.

1. Switch on the flash.
2. Charge the battery
3. Set the device to shooting mode.

The white balance setting is unsuitble.

1. Select the white balance depending on light source.

1. USB is not properly connected.
2. Error in Usb data transfer.
3. The hardware is not compatible.
4. The operating system is not installed correctly.

1. Check the Usb cable connection.

2. Plug out USB cable and reconnect it.

3. Ask your computer specialist dealer.

Poor cable connection.

1. Recconect the cable.

1. The memory card not been formated.
2. Daisy Multimedia recommends cards from the following brands: Dane-Elec, Toshiba, Infenion, Twinmos.

Format the card.
DM products works very well with other brands too, but sometimes problems may occur with non-branded or low-quality cards.

The memory card has not been inserted correctly.

Remove the card and reinsert it.